Trend Worktop Straight Guide archive
Tuesday 20 October 2009
Matt Long tries crosscutting with a power saw and the Trend Worktop Straight Guide
Trend have come up with this handy little design for a straight edge that can really help take the pain out of providing a clamped guide along which to guide power tools.
I used the guide for a kitchen worktop which needed a little trimming and found the device more than useful.
The soft pad adjustable friction clamps slide along the underside of the straight edge and when screwed tightly, get a nice grip on the workpiece.
The guide is 900mm (35in) long and is designed for worktops and the like, and will clamp materials up to 51mm deep. The slideable tape measure is perhaps of limited use, but can give a rough idea of how far into the workpiece to cut. With the use of a rigged-up pointer aligned with the cutter edge it could help give accurate cut length, but that seems a bit of a faff.
It's a decent enough bit of kit, but nothing that couldn’t be achieved with a good straight edge and a couple of clamps. However, this piece will keep itself true thanks to its extruded design, and the integral clamps do make it easier to use. The guide can also be combined with Trend's Varijig frame system, so if you already have that bit of kit then this addition makes more sense.