PC 205E Powercrafter
Thursday 04 November 2010
Nick Arnull looks at the Powercrafter kit and finds it to be a well made, sensibly priced tool for those wanting to pierce and add texture to their work
This unit arrived in a blown vinyl box complete with a selection of bits, so all that was needed to test the unit was a piece of work and air to power the hand piece. The compressor needs to deliver 1.5cfm at a constant 40psi. Upon initial examination the unit is well engineered and reasonably priced compared to similar units on the market. It claims to run at speeds from 350,0000-500,000rpm, which is pretty fast compared to your average electric rotary tool, such as a Dremel, which only runs up to around 50,000rpm.
Before use the unit needs to be oiled and then run for a few seconds - it also needs oiling every 20 minutes during use. This is quite straightforward but is necessary to give the bearings long life. The bits used are a dental-type. With a good selection available they last quite a considerable time, enabling the user to pierce or add texture onto the surface of the wood. It must be made clear that the unit is not for heavy erosion of the surface and should only be used to create surface texture - not for serious stock removal. I found it both easy and comfortable to use. No tools are required to change the bits - you simply press the plunger on the end and the bit is ejected - a feature I particularly liked.
The unit requires minimal pressure to do what is required but can create considerable dust and debris very quickly, so personal lung protection is essential. I would advise setting a small fan to one side and wearing personal dust protection when working with a high-speed air turbine such as the Powercrafter.
It generated no heat and I experienced no vibration, which is a real advantage if using it for long periods.
This is a well made, sensibly priced tool for those wanting to add texture and pierce their work.